Voodoo LabPedal Power MONDO Isolated Power Supply

This power supply is not cheap and will run you as much as an expensive effect pedal. That said I tried the cheap route and bought a couple Otraki Power Supplies which turned out to be a disaster. They were so noisy and my pedals emitted a lot of noise when engaged. I had to use a noise gate pedal to suppress it and make the setup usable. I finally decided to return them and invest in the Mondo. The difference is night and day. This thing is dead silent and I can use this one supply for all my pedals going to the preamp stage. I have a separate supply for my FX loop pedals.It is so versatile. You even have a couple outputs with a power sag feature. I wish the cables were a little longer but they work just fine. I Just have to be careful when moving my board around. This thing is too big to mount so having a little extra length would have been nice. I tested plugging my guitar directly into the amp versus running it through the board and the amp floor noise was the same. If you are going to invest in a pedal board array versus a multi effects board then you have to invest in A. A high quality power supply and B. High quality cables. As I have read, a pedal board is only as good as it's weakest link.

I use two of these on one pedal board and another one for my small pedal board. I am very happy with them. I also like that they have a power outlet on the back for daisy-chaining them together.

If you have the money, and see yourself using it, get one of these. For years, I resisted getting a Power 2 Plus because of the high ticket price, but honestly if i had gotten one of these initially, i would have saved hundreds of dollars.Over the years I have tried a number of similar products (including one-spot), and have had to buy (and subsequently lose!) lots of individual power supply units for pedals.The Power 2 Plus sounds way better than individual PSUs and one-spot style IMO. Greatly reduces noise, which is huge for me. It's small and well built, with mountings available for various pedal boards. It's easier to plug in to the outlet (PC style power cable).And with fewer parts, you're less likely to misplace stuff at the gig. That said, probably some kind of board or carrying apparatus should still be used.10/10 for me. These are very nice units

I use this Voodoo Lab Pedal Power 2 to power the first 8 pedals on my board. Tuner > Wah > Soul Food > DOD > Saucy Box > TS9 > Big Muff Pi... basically my drive section. (I have a different power supply powering my modulation and time based/FX loop section as to not share grounds) The Voodoo Lab works great. I have zero noise or hum. As you can see I don't have the most expensive pedals and I don't trust solderless patch cables. My rig is solid. Thanks Voodoo Lab

Yes, its expensive. But it works. Comes with a great variety of cables for all the power requirements of your boxes. Built like a tank. Your noisy boxes (distortion, overdrive, DS-1 etc...) will still be noisy, but a little less so. Your quiet boxes (chorus, echo) will be silent! No annoying humming. Eliminates a major source of noise...your power supply. I never realized how much noise was being created by the "daisy chain" power supply cord that you can buy to plug all your guitar pedals into one outlet. They are a real source of major noise. The Pedal Power 2 plus eliminates this! You can plug 8 standard guitar pedals into this box at once. Enough for almost anyone''s chain of effects. No regrets.

In the life of every electric guitarist, pedals start to become important to your sound. Batteries provide the cleanest power but are expensive and plagued by the fact that we never can remember to unplug the cable. Dooh! The voodoo Pedal Power 2 Plus is a fine isolated power supply. I tested on my pedal board and found it only added 2-3 more dB to my ambient guitar signal (ambient as tested was 43-44dB which increased to 45-46dB). Not bad at all. Since I'm also an electrical engineer with time and parts to spare, I built a 3 channel isolated power supply out of an old PC ATC power supply (which uses a switching power supply rather than the voodoo linear power supply). I put in about $20 of parts I got on Ebay, and was able to build a supply that I'm happy with, and performed very similar to the voodoo. I could not make a distinction audibly, but when I tested it with my dB meter, it did add about 6-7dB above ambient (ambient was the same as above and sound increased to about 51-53). I'm not surprised it did worse given the underlying supply is switching type, which inherently are noisier. So a little worse than voodoo, but like I said that 6-7dB difference was hardly noticeable in the room, and for 20 bucks and a little bit of solder, I'm pretty happy with the results!The reason I'm giving 4 stars and not 5 are the following:-Current limits are absolutely appalling low 100mA, except for 5-6 which can go to 250mA. As more fancy Line6 and other pedals that demand more power come into to play, you'll find yourself tapped out quick and needing the more expensive Pedal Power DIGITAL model. My RC30 looper pedal needs almost 200mA, so even that is borderline. For comparison, my 3 isolated power channels can do 1-2amps (I have it fused to 2amp) per channel thanks to nice heat sinks and a robust fan. The size of mine is not much bigger than the pedal power 2.-What's with the short cables? 18" is not enough for most pedal boards even if you put the the supply in the center (and I don't want to do that). I ended up making my own cables. Perhaps if you have the kind that goes under the board you're ok, but I don't have one like that and neither do other people. Voodoo labs does carry longer cables (24" and 36") on their website. There are not decent quality right angle plugs sold anywhere(at least I haven't found them). Otherwise I would make my own cables.-Only 6 right angle cables? Who even uses the straights anymore? With the cost of pedal board space so high, it makes no sense. More cables please!-It really would benefit from a power switch in my opinion. I guess people put this in a place that can't be reached? But still. A switch would be nice.-Pricey. Look, I know you have to pay to get good stuff, but this this too much. A lot of other good isolated supplies out there are being made and not nearly this much. Probably is 40 overpriced.Pros:-Yes, there are alot of good things about this that people have already comment on. Clean power, helps cut down hiss, reliable, works well with pedaltrain (if you have one...). All true, so I won't dwell on what's already been mentioned.-Fantastic customer service! I sent an email asking a question and they gave me a call a few hours later. They listened carefully to my problem and found me a satisfactory solution very quickly. The representative was very courteous and had excellent customer service skills. I was very impressed!4 stars. Good but pricey, poorly thought out cables

Been years and I dropped it once from about a foot. This thing is solid. Not sure about their pedals and other stuff but their power supplies are solid. They have different cables to connect my line6 and mxr 10 band eq too so it’s easy to consolidate all your connections. Worth the money. It’s great for people that want to expand their board later on. If you think you’ll need even more outputs than this you can get splitters or even better, a Mondo. They’re seriously an industry standard.