In Wall Speaker Volume Control - Home Audio Smart 2-Channel A/B Dual Channel Speakers Controller Selector Pod Box - Rotary Knob Fader Control Up to (2) Pair of Indoor or Outdoor Speakers - Pyle PVCD15

مراجعة

Perfect just as needed

This was my second attempt. The first one (different brand) came broken and I had to return it but I noticed that it was too deep for the electrical box. This one fits... barely, but it fits in a standard electrical box. Very important because most of these types of units have a large circuit board and they do not fit in a standard box. The message is that if you are using a standard surface mount or recessed electrical box to install your volume control make sure you check the dimensions. This one fits and it is also nice that it has two volume controls, one for each speaker. Works as advertised and did I mention that it FITS???

Pero me gustaría si era mucho mas fino. Cambiar un numero da mucho cambio?

I have a pair of high-end speakers in my living room. I have another pair of (smaller) speakers for my 'rear speakers'. My rear speakers and smaller and require less power to reach higher volumes (decibel rating). I needed to find a way to control the rear speaker volume. I searched Amazon.com for a compatible unit that I could use to control rear speaker volume, but didn't find anything that would fit my need. I decided I could build a in-line volume control box using all Amazon products, i.e. volume control, female banana jacks, male banana jumper cables and the 3=gang electrical box. Bottom line -it works, and all the components needed were found on Amazon.com.

This inexpensive solution to control external extended speakers volume works very well. The 150watt wattage provides for more then enough power.In this application we are using an older Panasonic receiver with a single volume control for both main and remote speakers. This arrangement provided no ability to control the volume independently between sets of speakers. The Pyle provided the solution.The controls are notched providing ample range and adjustment to meet the needs of two sets of speakers. One set, the main, are using the volume control of the receiver and the second set, (remote) wired through the Pyle, are adjusted to achieve the desired fade/balance between the two sets.In this situation the two sets of speakers are not matched in that the remote set is more efficient(loud) and this Pyle controller provides the ability to reduce the volume(fade) providing main/remote balance in the room.Once the (Fade) is set between the two sets of speakers the main volume allows for balanced volume up/down control. Great solution I'm delighted listening to classic music in my workshop!